Pneuma System Co.,Ltd.

Fig. 5FCM

KITZ Fig. 5FCM JIS 5K GATE VALVE Deslgned to JIS B2031 CAST IRON VALVE Fig. 5FCM *Bronze trim

ขายแล้ว 0 ชิ้น

0 THB ฿0
 

 

NX-1

NIDEX Series NX-1 – STAINLESS STEEL BALL VALVE บอลวาล์วสแตนเลส สตีล Reduced Port วัสดุตัวเรือนทำจากสแตนเล สสตีล เชื่อมต่อด้วยเกลียวภายใน ขนาดตั้งแต่ ¼ นิ้ว ถึง 2 นิ้ว

ขายแล้ว 0 ชิ้น

0 THB ฿0
 

 

IGA-NRS-F3-1

ARITA IGA-NRS-F3 Ductile Iron Gate Valve (NRS), PN 16

ขายแล้ว 0 ชิ้น

0 THB ฿0
 

(มีหลายคุณสมบัติให้เลือก)

Best Seller

AP-00

SIRCA Pneumatic actuator หัวขับวาล์ว หัวขับลม เซอร์ก้า Single Acting (Spring Return) มีลักษณะการทำงานคือเมื่อจ่ายลมเข้าหัวขับ หัวขับจะเปลี่ยนสถานะ เช่น จากปกติปิดอยู่ก็จะเปิดออกเมื่อมีการจ่ายลม แต่หากหยุดจ่ายลมเข้าหัวขับ ภายในหัวขับจะมี Spring ดันกลับให้มีการปิดทันที Double Acting มีลักษณะการทำงานคือเมื่อจ่ายลมเข้าครั้งหนึ่งเพื่อเปลี่ยนสถานะ แล้วสถานะของ valve จะค้างไว้เป็นสถานะล่าสุด หากเราต้องการเปลี่ยนสถานะกลับจะต้องจ่ายลมเข้าอีกครั้งหนึ่ง มีให้เลือกหลาย SIZE หลายขนาดสนใจสินค้าติดต่อเราเพื่อขอใบเสนอราคาได้ทันที

ขายแล้ว 0 ชิ้น

0 THB ฿0
 

(มีหลายคุณสมบัติให้เลือก)

ViDos

EBRO ARMATUREN ViDos CONTAINER VALVE SPECIAL APPLICATIONS Vibrating Disc keeps products in motion A wafer type process valve with a vibrator mounted on the lower shaft. The disc is set into linear vibrations before opening to keep the product in motion thus reducing compression. The frequency is controlled via air pressure.

ขายแล้ว 0 ชิ้น

0 THB ฿0
 

 

TW 80/TW 100

EBRO ARMATUREN TW 80/TW 100 CONTAINER VALVE SPECIAL APPLICATIONS wafer type butterfly valve These valves are designed to be used with tankers silos and road vehicles.

ขายแล้ว 0 ชิ้น

0 THB ฿0
 

 

TV

EBRO ARMATUREN TV Knife Gate Valves Knife Gate Valve Stafsjö’s knife gate valve TV is used as an isolation valve for a transmitter or sensor on a tank for which a short face-to-face length is required.

ขายแล้ว 0 ชิ้น

0 THB ฿0
 

 

SLX

EBRO ARMATUREN SLX Knife Gate Valves High pressure knife gate valve Stafsjö’s knife gate valves SLH and SLX are designed for the most demanding high pressure applications with slurry and other abrasive media where operation reliability and low life cycle cost are emphasized. The SLH is designed for pressure up 20 bar/290 psi while the SLX is designed for 50 bar/720 psi.

ขายแล้ว 0 ชิ้น

0 THB ฿0
 

 

SLF

EBRO ARMATUREN SLV Knife Gate Valves Knife Gate Valve for abrasive slurry. Stafsjö’s knife gate valves SLV and SLF are particularly suitable for abrasive and demanding slurry where operation reliability and low life cycle cost are emphasized. The SLV is a lugged version while the SLF is fully flanged and especially suitable on old non-centred pipes or low pressure applications.

ขายแล้ว 0 ชิ้น

0 THB ฿0
 

 

SLV

EBRO ARMATUREN SLV Knife Gate Valves Knife Gate Valve for abrasive slurry. Stafsjö’s knife gate valves SLV and SLF are particularly suitable for abrasive and demanding slurry where operation reliability and low life cycle cost are emphasized. The SLV is a lugged version while the SLF is fully flanged and especially suitable on old non-centred pipes or low pressure applications.

ขายแล้ว 0 ชิ้น

0 THB ฿0
 

 

D2G

EBRO ARMATUREN D2G Knife Gate Valves Knife Gate Valve with two plates. Stafsjö’s knife gate valve D2G is a bi-directional tight valve with full bore. The valve is equipped with two hard chromed gates that works towards each other in the bore, which gives an extremely fast operation. This shut-off performance along with its flow characteristics makes it suitable for contaminated media or reject handling. The valve should be mounted only in a vertical pipe line.

ขายแล้ว 0 ชิ้น

0 THB ฿0
 

 

JT

EBRO ARMATUREN JT Knife Gate Valves Knife Gate Valve This complete Junk Trap is designed for really tough process conditions handling difficult and abrasive media. The JT is specially designed to minimize turbulence, erosive wear, and build-up of solids and reject material.

ขายแล้ว 0 ชิ้น

0 THB ฿0
 

 

วาล์วกันกลับ (Non-Return Valve หรือ Check valve) เป็นวาล์วทำหน้าที่บังคับให้การไหลเป็นไปในทิศทางเดียวไม่เกิดการไหลย้อนกลับเพื่อป้องกันปัญหาต่าง ๆ ของระบบที่อาจจะเกิดขึ้น เช่น หากน้ำไหลย้อนกลับเข้าปั๊มจะได้ให้ระบบรวน นำไปสู่อายุการใช้งานที่ไม่เหมาะสม

หน้าแปลน (Flange) คือ สิ่งทำหน้าที่เชื่อมต่อระหว่างปลายของท่อ หรือ เชื่อมต่อกันระหว่างท่อกับอุปกรณ์อื่นๆ หรือ เชื่อมต่อกันระหว่างอุปกรณ์ 2 ชนิด การเชื่อมหน้าแปลน คือ การเชื่อมต่อหน้าแปลนแบบถอดได้ โดยจะมีปะเก็นและสลักเชื่อมต่อกันเป็นโครงสร้างทำหน้าที่ให้หน้าแปลนยึดติดกัน หน้าแปลนท่อ คือ หน้าแปลนที่ใช้สำหรับท่อในการติดตั้งกับหน้าแปลนอื่นๆ โดยหน้าแปลนจะเชื่อมติดอยู่กับทั้ง 2 ด้านของอุปกรณ์ คือ ทางเข้า และ ออก หน้าแปลนท่อจะมีสลักและรูหน้าแปลนให้สลักเชื่อมติดกันได้ดี และจะมีปะเก็นปิดผนึกสลักซ้ำอีกที

บัตเตอร์ฟลายวาล์ว (BUTTERFLY VALVE) หรือ วาล์วปีกผีเสื้อ เป็นวาล์วประเภท ควอเตอร์เทิร์นวาล์ว (Quarter Turn Valve) หรือ หมุนได้ 1/4 ของวงกลม ใช้ทำหน้าที่ เปิด/ปิด 0-90 องศา บัตเตอร์ฟลายวาล์ว (Butterfly valve) มักเป็นที่นิยมในระบบอุตสาหกรรมหลายๆประเภท ไม่ว่าจะเป็นฝ่ายผลิตของอุตสาหกรรมต่างๆ ในระบบท่อหล่อน้ำเย็นของเครื่องปรับอากาศขนาดใหญ่ ในงานประปา ในระบบน้ำดีน้ำเสีย ฯลฯ เนื่องมาจากราคา Butterfly Valve หรือ วาล์วปีกผีเสื้อมีราคาไม่สูงนัก อีกทั้งยังมีน้ำหนักเบาเมื่อเทียบกับวาล์วประเภทอื่นๆ มีความทนทานและไม่ต้องการการบำรุงรักษามาก ใช้งานง่ายและถูกสร้างมาสำหรับงานประเภทเปิด/ปิดสุด และการใช้งานแบบหรี่ สามารถใช้งานได้ครอบคลุมทั้งของเหลวและก๊าซ รวมถึงน้ำ ก๊าซธรรมชาติ น้ำมัน จากสัตว์ พืชและแร่ กรดเจือจาง ฯลฯ

BK Valve หัวขับไฟฟ้า(Electric Actuator) , 522 ผู้ชม

SDPC กระบอกลม(Air Cylinder) , 461 ผู้ชม

BK Valve หัวขับไฟฟ้า(Electric Actuator) , 435 ผู้ชม

PU TUBE สายลม(Polyurethane Tube) , 593 ผู้ชม

NUOVAFIMA เกจ์วัดความดัน(Pressure Gauge) , 505 ผู้ชม

Type your text here...
Powered by MakeWebEasy.com
เว็บไซต์นี้มีการใช้งานคุกกี้ เพื่อเพิ่มประสิทธิภาพและประสบการณ์ที่ดีในการใช้งานเว็บไซต์ของท่าน ท่านสามารถอ่านรายละเอียดเพิ่มเติมได้ที่ นโยบายความเป็นส่วนตัว  และ  นโยบายคุกกี้